Skip to content

Why is my film's sound too quiet or too loud?

Most "too quiet" and "too loud" complaints come down to loudness - how loud a film sounds overall, measured in LUFS (loudness units relative to full scale). A peak meter that stays out of the red tells you a mix won't distort, but not how loud it will feel. Two mixes with the same peaks can sound very different in loudness.

What Long Play does

Long Play sets every film to the same overall loudness, -23 LUFS, the European broadcast standard (EBU R128). It does this with one steady volume change for the whole film, so your quiet scenes stay quiet and your loud scenes stay loud - the balance of your mix doesn't change. A limiter gently holds back the rare peak that would otherwise distort.

This means viewers can move from one film to the next without reaching for the volume, and a quiet mix isn't buried next to a loud one. Your original file is never changed - this only applies to the streaming copy.

If your film still sounds too quiet

  • The dialogue is low compared with the music and effects. Overall loudness is fine, but the words are hard to hear. This is a mix balance problem - bring the dialogue up, or the music and effects down, in your editor and replace the file.
  • The mix has a very wide range. A film with whispered scenes and very loud action can feel quiet in the soft parts on laptop and phone speakers. Gentle compression on the dialogue helps.
  • The sound was recorded very low. Raising the level also raises any hiss or room noise. Noise Reduction can help with steady background noise.

If your film sounds too loud or harsh

A mix pushed hard to sound loud (heavily compressed or limited) will be turned down to -23 LUFS, but it can still feel flat and tiring because the quiet moments were squashed in the mix. A more open mix with real quiet passages usually sounds better here than a loud one.

Mixing for Long Play

  • Aim for around -23 LUFS integrated for the whole film, with peaks below about -2 dBTP (true peak). Most editing apps have a loudness meter: in many you'll find it as "loudness" or "LUFS" in the audio meters.
  • Keep dialogue clear and steady - it's what viewers adjust the volume for.
  • Check the mix on laptop speakers and headphones, not just studio monitors.
  • If you mix for another standard (for example -24 LUFS for US broadcast, or louder for music sites), that's fine - Long Play will even it out with one steady change either way.

5.1 surround mixes are combined to stereo first, then set to -23 LUFS, so dialogue in the centre channel stays at the right level.

← Back to Picture and Sound